Winches, Recovery Gear & Loading Ramps

Find 12 V electric winches for vehicle and trailer applications, replacement controls and rope, recovery equipment and loading ramps. Match the whole setup to the intended load and mounting arrangement, not just the largest capacity on the box.

Shop the collection

Related reading

Is the winch for an ATV, trailer or 4WD?

Pulling a rolling vehicle onto a trailer is a different job from recovering a vehicle stuck in mud. Vehicle weight, slope, rolling resistance and how deeply it is stuck change the force required. A compact ATV winch and a larger 4WD unit also need different mounting space and electrical support.

The advertised pulling capacity is normally a first-layer rating. More rope built up on the drum reduces the available pull. Choose with the manufacturer’s application guidance and performance data; the rating is not a guarantee that every vehicle below that weight can be recovered.

Will it fit your mount and electrical system?

Confirm the winch’s mounting pattern, overall dimensions, fairlead position and access to the clutch before ordering. The mount and its connection to the vehicle or trailer must be designed for the pulling loads. A remote control cannot compensate for an unsuitable mount.

A 12 V label describes voltage, not the full electrical requirement. Battery capability, cables, isolation and the installation arrangement must suit the particular winch. Do not treat a low-current accessory socket as a winch power supply.

Steel cable, synthetic rope or a replacement remote?

Synthetic rope is lighter to handle than comparable steel cable, but needs protection from abrasion and heat. Steel cable needs inspection for damaged wires and corrosion. Both require the correct drum, fairlead and handling arrangements; a conversion is more than swapping the line.

For a replacement control, match the winch model and control system. Similar-looking wireless handsets may use different receivers, voltages or connections. A rope, solenoid or remote listing is an accessory, not a complete winch.

Buying ramps or recovery equipment alongside the winch?

A loading ramp must suit the wheel track, tyre width and loading height as well as the weight. Check whether its rating applies to one ramp or a pair: a pair rated for a stated total is not two ramps each rated for that total. Kerb ramps, trailer loading ramps and recovery boards have different jobs.

For recovery gear, identify the intended load and compatible rated attachment points. A tow ball is not a recovery point. Recovery equipment needs appropriate training and a planned exclusion area, not just enough space in the boot.

Useful answers

Winches, Recovery Gear & Loading Ramps: your questions

Can a recovery winch lift an engine or suspend a load?

No, unless that exact equipment is separately designed and rated for the lifting task. A recovery winch’s pulling capacity is not a hoist rating. Use a properly rated hoist and lifting system for suspended loads.

Does a wireless remote mean the winch is ready to install?

No. The package still needs the correct mounting system, electrical installation and compatible control components. Some listings supply only the remote or receiver, so distinguish the accessory from a complete winch kit.

Can I replace steel cable with synthetic rope?

Only when the winch manufacturer permits a compatible conversion. Drum condition, heat from the brake, rope specification and fairlead compatibility matter. Do not select rope by diameter or advertised strength alone.